Homemade wine guide

Yeast Nutrient for Wine: DAP, Fermaid K or Fermaid O, and How Much per Gallon

By The MyHomeWine Team · Updated

As an Amazon Associate we earn from qualifying purchases. How we choose products.

Wine yeast nutrient powder measured with a spoon beside a one gallon jug of fermenting must
Illustration
On this page
  1. What Yeast Nutrient Does
  2. Types of Yeast Nutrient
  3. How Much Yeast Nutrient per Gallon
  4. When to Add Yeast Nutrient
  5. Can You Make Wine Without Yeast Nutrient?
  6. Which Yeast Nutrient to Buy

Wine yeast nutrient is a powder of nitrogen, vitamins and minerals that you add to the must so the yeast can finish the job without stress. Three kinds cover almost every home batch: a general yeast nutrient or DAP blend (the classic 1 teaspoon per gallon product), Fermaid K (DAP plus yeast-derived nitrogen and vitamins), and Fermaid O (all organic, no DAP). Which one you buy matters less than adding it at the right time and in the dose the maker gives.

The short version of the doses: Lallemand gives Fermaid K at 25 g/hL in two additions, about 1 gram per gallon in total, and Fermaid O at 40 g/hL in two additions, about 1.5 grams per gallon. Home Brew Ohio gives its general nutrient at 1 teaspoon per gallon before fermentation starts. We did not run trials; every number below comes from Lallemand, Scott Laboratories, WineMaker magazine, Brew Your Own, the Australian Wine Research Institute (AWRI), NDSU Extension or the federal wine rules, and each is named where it appears.

What Yeast Nutrient Does

NDSU Extension describes yeast nutrient as an energizer that promotes a rapid start to fermentation, and as a food-grade version of the fertilizers urea and diammonium phosphate. It adds that a lack of nutrient can stress the yeast and give the wine a hydrogen sulfide odor.

The AWRI says the same thing from the lab side. Hydrogen sulfide can be produced in excess when yeast run out of nitrogen, and the AWRI lists inadequate free amino nitrogen and a shortage of B vitamins among the causes. It also notes that Australian juices can be low in nitrogen, so winemakers often add diammonium phosphate. In other words, the powder in the jar is not a ritual: it replaces what the must does not have.

Which Musts Run Short

Honey is the clear case. Brew Your Own magazine says that honey is poor in nutrients, particularly nitrogen, which gives a very slow fermentation unless you add some. Fruit and flower wines made with lots of added water and sugar are a likely second case, because the sugar and water add calories without adding nitrogen. That second point is our reasoning, not a measured figure, so the safe habit is simple: follow the nutrient line in your recipe, and add more care for mead.

Nutrient Is Not Pectic Enzyme or Sulfite

Nutrient feeds the yeast. It does not clear the wine or protect it from oxidation. Our guide to wine making additives shows where each powder sits in the process, and the Campden tablet page covers the sulfite side.

Types of Yeast Nutrient

The names on the shelf blur together. Here is what each one is, using the maker's own description.

DAP and General Yeast Nutrient

Diammonium phosphate is an inorganic nitrogen salt that yeast take up fast. The federal list of wine treating materials, 27 CFR 24.246, authorizes it as a fermentation aid with a ceiling of 8 pounds per 1000 gallons (0.96 g/L). By our arithmetic that is about 3.6 g per gallon, which is the legal line for commercial wine, not a target for your jug. Most home products are blends: Keystone Homebrew lists the contents of its Fermax as diammonium phosphate, magnesium sulfate, yeast hulls, B vitamins and calcium salts. The home dose is on the label, typically 1 teaspoon per gallon.

Fermaid K

Lallemand describes Fermaid K as a blend: DAP for inorganic nitrogen, amino nitrogen from yeast for organic nitrogen, magnesium sulfate, vitamins (thiamine, folic acid, niacin, biotin, calcium pantothenate) and inactivated yeast. The inactivated yeast cell walls adsorb toxic medium-chain fatty acids. Scott Laboratories calls it immediately available nutrients for fermentations that need to start quickly. Brew Your Own notes that Fermaid K is generally easier to find and less expensive than Fermaid O, and it covers vitamins too.

Fermaid O

Lallemand's description is blunt: 100% yeast autolysate, rich in organic nitrogen, with no added DAP and no added micronutrients. Scott Laboratories says the amino acids and peptides are assimilated gradually and can be stored and used later in fermentation. That slower release is why mead makers like it. Scott lists the measurable yeast available nitrogen (YAN) at 40 g/hL as 16 ppm, with 64 ppm YAN equivalents; for Fermaid K at 25 g/hL it lists 25 ppm. Do not compare the dose numbers across products without that context.

Rehydration Nutrient (Go-Ferm)

Go-Ferm is the third thing you may see in a recipe: a nutrient for the yeast rehydration step, not for the must. BYO gives the rate as 1.25 grams per gram of yeast. For a plain fruit wine you can skip it. For a high gravity mead or a restart, it is part of the plan, and Lallemand's Fermaid O page suggests pairing the product with Go-Ferm when you want to avoid DAP.

How Much Yeast Nutrient per Gallon

The table converts each maker's own dose to grams for 1 and 5 gallons. The conversion is ours (1 gallon is 3.785 L, so 1 g/hL is about 0.038 g per gallon); the doses are the makers'. Where two makers disagree, the table shows both.

ProductMaker dosePer 1 gallonPer 5 gallons
Fermaid K (Lallemand)25 g/hL, in two halvesabout 0.95 gabout 4.7 g
Fermaid K (Scott Laboratories)25 to 50 g/hLabout 0.95 to 1.9 gabout 4.7 to 9.5 g
Fermaid O (Lallemand)40 g/hL, in two halvesabout 1.5 gabout 7.6 g
Fermaid O (Scott Laboratories)10 to 40 g/hLabout 0.4 to 1.5 gabout 1.9 to 7.6 g
Fermax general nutrient1 teaspoon per gallon (Home Brew Ohio)1 tsp5 tsp

A gram scale that reads 0.1 g turns these numbers into something you can use. At these sizes a spoon is a poor measure, because powders and granules pack differently. For Fermaid K and O the Lallemand rate also reads as 1 lb per 1000 gallons per addition for K and 3 1/2 lb per 1000 gallons in total for O.

If You Use a General Yeast Nutrient

The Home Brew Ohio listing says 1 teaspoon per gallon prior to fermentation beginning. Keystone Homebrew gives typical use as between 1 and 4 grams (1 teaspoon) per gallon, with half added at the start and the rest midway. Those two sources agree that 1 teaspoon per gallon is the normal home dose.

If You Make Mead

Brew Your Own gives a formula for Fermaid O in mead: grams = batch size in gallons x YR x Brix / 5, where YR is the yeast requirement (0.75 for low nitrogen yeast, 0.90 medium, 1.25 high). Its worked example is 5 gallons x 0.75 x 32.2 Brix / 5 = 24.1 g, split into four additions of 6 g. For a 1 gallon batch near 1.100 (about 23.6 Brix, our conversion) the same formula gives about 3.5 g in total, or about 0.9 g per addition. Treat it as a starting point and check it against your yeast maker's data.

When to Add Yeast Nutrient

Timing is half of the dose. The makers agree on the shape of it: some at the start, the rest during the first third of the fermentation.

At the Start

Lallemand's first Fermaid K addition is at the end of the lag phase, which its page puts at 6 to 12 hours after inoculation. The Home Brew Ohio listing for Fermax says to add it before fermentation begins. Both are fine; the difference is that Fermaid products are designed to go in a little later, once the yeast are growing. Do not pour dry powder straight into a foaming must. Scott Laboratories says to suspend it in water and mix well before adding, to avoid CO2 release and overflow.

In Stages

Lallemand splits both Fermaid products in two: half at the end of the lag phase and half at around 1/3 sugar depletion. Scott Laboratories gives 1/3 sugar depletion for Fermaid K, and a 2 to 3 degree Brix drop and/or 1/3 depletion for Fermaid O. To find 1/3 depletion, take a gravity reading with the hydrometer: for a must that started at 1.090, you are looking for about 1.060. That is our arithmetic, so check it against your own starting gravity.

Staggered Additions for Mead

Brew Your Own describes TOSNA-2, short for Tailored Organic Staggered Nutrient Addition. It uses Fermaid O with Go-Ferm at rehydration, and Fermaid O goes in as equal additions at 24, 48 and 72 hours after pitching, then at either one week or when the 2/3 sugar break is complete. The same article mentions a similar schedule with Fermaid K, and notes K is generally easier to find and less expensive. Other mead sources shift the last addition, so a schedule from a calculator is a guide, not a law. Our mead guide shows where the additions sit in the full process.

When It Is Too Late

Nutrient works on yeast that are still growing. Once fermentation has stalled, adding more is part of a restart, not a cure. The Lallemand and WineMaker restart protocols add nutrient together with fresh yeast, and WineMaker uses 0.5 g per gallon of Fermaid K for a wine above 3 Brix, and none below 1 Brix. See our stuck fermentation guide.

Can You Make Wine Without Yeast Nutrient?

Yes, and plenty of people do. The question is what you risk. NDSU Extension says a lack of nutrient can stress the yeast and bring a hydrogen sulfide odor, and the AWRI lists too little nitrogen and B vitamins as causes of excess H2S. Some musts get through unaided, and we have no data on which ones, so treat nutrient as cheap insurance. A diluted fruit must, a flower wine or a mead is where skipping it hurts most. The cost of nutrient is small next to a spoiled batch.

If you have already skipped it and smell rotten eggs, do not panic and do not bottle. Our wine faults guide covers what to do.

Which Yeast Nutrient to Buy

For a 1 gallon fruit wine, the cheapest route is the general nutrient you will use most often, and our best wine yeasts guide shows what to pair it with. For mead, buy Fermaid O. For a bigger batch or a stuck wine, Fermaid K is the practical choice. All of them are budget items.

Yeast nutrients for wine and mead

One general nutrient, one DAP blend and one organic nutrient. All are in the budget tier ($).

  1. 1General nutrient for fruit wine

    Fermax Yeast Nutrient, 1 lb

    The plain 1 teaspoon per gallon nutrient that fruit wine recipes commonly call for, in a size that lasts many batches.

    Check price on Amazon

  2. 2Fermaid K

    North Mountain Supply Fermaid K, 4 oz jar

    The blend with DAP, organic nitrogen and vitamins, at Lallemand's 25 g/hL in two additions.

    Check price on Amazon

  3. 3Fermaid O for mead

    Fermaid O Yeast Nutrient, 2 oz

    The all organic option for mead and staggered additions.

    Check price on Amazon

It supplies the nitrogen, vitamins and minerals the yeast need to grow and finish a fermentation. NDSU Extension calls it an energizer that promotes a rapid start, and says a lack of it can stress the yeast and cause a rotten egg odor. Honey and diluted fruit musts are the ones most likely to need it.
Brew Your Own gives a formula: grams of Fermaid O = gallons x YR x Brix / 5, with YR 0.75 for low nitrogen yeast. For 1 gallon at about 1.100 that is roughly 3.5 g in total, split in four doses at 24, 48 and 72 hours and at about one week. Check it against your yeast maker's data.
Heat is one: WineMaker puts the ideal red fermentation range at 79 to 86 degrees F and says anything above may slow yeast, stop them and possibly kill them. High alcohol is another, especially for wild yeast, and a large excess of sulfite can stop a ferment starting. Toxic fatty acids produced by the yeast itself can also inhibit them.
Not always. DAP is inorganic nitrogen that yeast take up quickly; Scott Laboratories says Fermaid O's amino acids are assimilated gradually and can be used later in the ferment. DAP-based Fermaid K is cheaper and fine for fruit wine; Fermaid O is the usual pick for mead. We have not run side by side trials.

Wine is for adults of legal drinking age. Enjoy it responsibly.